Wise SyncroLED RGB Slave 350mA 21W
Product code WISESYNCRGB 21S
£148.32
ex. VAT
The Wise SyncroLED RGB Slave offers the same capability as your standard Chameleon yet with less wiring needed for it. The master receives the signal from the transmitter and then passes the signal on to the slave wirelessly without the need for cables between the master and slaves. Each pack only requires to be wired to a power supply
Caution: The warm white produced by RGB products is not the same as the warm white produced by single coloured products. By mixing the colours to create warm white a hint of Red, Green, or Blue may appear.
Wise Controls Introduction Video
- Wireless platform — no rewiring between switches and receivers
- Programmed by button-press — no software, hub or app required to set up
- Free installer training and UK technical support from the Wandsworth team
Free training available for installers — book a slot.
Specifications
| Radio Frequency | 868.3 MHz |
| Range for Metal Switch | 50m Max Line Of Sight |
| Range for Plastic Switch | 100m Max Line Of Sight |
| Dimensions | |
| Height | 35mm |
| Length | 165mm |
| Width | 47mm |
| Electrical | |
| Amperage | 350mA |
| Input Voltage | 24V DC |
| Maximum Wattage | 21W |
| Minimum Wattage | 1W |
| General | |
| Construction | Plastic |
| IP Rating | IP20 |
Downloads
Spec sheets
Manuals & instructions
Common questions
Do I need Wi-Fi for this to work?
No. The Wise platform runs on radio frequency (RF), independent of your home Wi-Fi or broadband. The system continues to function during internet outages.
Is special programming software required?
No software, hub or laptop is needed for standard setup. Pairing is done by pressing buttons on the receiver and transmitter in sequence — any qualified installer or competent homeowner can do it.
Can I add this to an existing Wise installation?
Yes. Any new Wise receiver or transmitter pairs directly with existing kit. There's no version lock — Wise Box receivers, Scene controllers and Fusion dimmers all live on the same RF platform regardless of generation.
Does it need a qualified electrician to install?
Wireless transmitters (keypads, remotes, PIRs) can be installed by a competent person without mains work. Receivers and dimmers wire into the mains supply and must be installed by a qualified electrician. Free training is available — see our training page.
Where can I buy it?
Wise Controls equipment is sold through authorised electrical wholesalers nationwide — see our stockists page for the full list, or contact us for the closest distributor to your project.