Wise Chameleon Slave 12V/24V 150W/300W
Product code WISERGB STRIP SL
£70.25
ex. VAT
The Wise Chameleon Slave is a 12V 150W / 24V 300W LED colour change controller and LED dimmer. It is used with any of the Wise Chameleon Master receivers. Different types of Wise Chameleon Slave can be connected together.
The slave communicates with the master receiver via a data cable (40cm length). The Slave stays synchronised with the master receiver.
Power Supply
The Wise Chameleon Slave requires a 12V or 24V DC power supply. Choose the wattage of the power supply that matches your load.
Caution: The warm white produced by RGB products is not the same as the warm white produced by single coloured products. By mixing the colours to create warm white a hint of Red, Green, or Blue may appear.
Wise Controls Introduction Video
- Wireless platform — no rewiring between switches and receivers
- Programmed by button-press — no software, hub or app required to set up
- Free installer training and UK technical support from the Wandsworth team
Free training available for installers — book a slot.
Specifications
| Maximum Slave per Master Receiver | Unlimited |
| Minimum Spacing Between Receivers | 5mm |
| Dimensions | |
| Height | 35mm |
| Length | 165mm |
| Width | 47mm |
| Electrical | |
| Input Voltage | 12V DC / 24V DC |
| Maximum Wattage | 300W |
| Minimum Wattage | 1W |
| Output Voltage | 12V DC / 24V DC |
| General | |
| Construction | Plastic |
| IP Rating | IP20 |
Downloads
Spec sheets
Manuals & instructions
Common questions
Do I need Wi-Fi for this to work?
No. The Wise platform runs on radio frequency (RF), independent of your home Wi-Fi or broadband. The system continues to function during internet outages.
Is special programming software required?
No software, hub or laptop is needed for standard setup. Pairing is done by pressing buttons on the receiver and transmitter in sequence — any qualified installer or competent homeowner can do it.
Can I add this to an existing Wise installation?
Yes. Any new Wise receiver or transmitter pairs directly with existing kit. There's no version lock — Wise Box receivers, Scene controllers and Fusion dimmers all live on the same RF platform regardless of generation.
Does it need a qualified electrician to install?
Wireless transmitters (keypads, remotes, PIRs) can be installed by a competent person without mains work. Receivers and dimmers wire into the mains supply and must be installed by a qualified electrician. Free training is available — see our training page.
Where can I buy it?
Wise Controls equipment is sold through authorised electrical wholesalers nationwide — see our stockists page for the full list, or contact us for the closest distributor to your project.